Just try to ping with the command, ping vr OMCN and let us know the results. Admin State: Enabled Tagging: 802.1Q Tag 116. Interface with name WCGUPLINK-OAM created by user. You are already redistributing your static routes into the OSPF. SRBHPP-EOAMSW-01.3 show vlan WCGUPLINK-OAMVLAN. I have a Netgate appliances 2100 installed with pfSense Plus. The VLAN name is WCGUPLINK-OAM Here are the output SRBHPP-EOAMSW-01.3 show vlan WCGUPLINK-OAMVLAN Interface with name WCGUPLINK-OAM - 27346 - 3 This website uses cookies. Hello all, Need help on issue I encountered. Now I can ping between VLAN and also access the resource. Is this something do with the fact that the 192.168.1. Create the new Layer 3 VLAN on your switch & then have a routing on your router to point back to the routed interface of your switch. I have managed to resolve the issue by enabling 'Asymmetric VLAN' on DLINK switch. Show ip route shows the appropriate routes back via the directly connected interface/suninterface for vlan 1 and vlan 20 subnets.Ĭan someone kindly explain why I am unable to ping 192.168.1.1? (I can ping 192.168.1.1 directly from the switch). ![]() I've configured one of my access ports to vlan 20, connected my laptop and successfully leased an ip address from the dhcp scope I created for vlan 20.įrom my client, with an IP address of 192.168.20.xxx, I am able to ping the SVI gateway and the sub interface of the router, 192.168.20.254 and 192.168.20.1. No problems here.įrom the same client, I am not able to ping the G0/1 router interface 192.168.1.1 but I can ping the switch SVI of 192.168.1.254. ![]() RIPv2 from network delivers the route 0.0.0.0/0 to the switch. ![]() I made the following changes to the switch and the switch was no longer available to telnet ssh https. I had a N2048 switch connected to our network with an IP address on a vlan with a static default route. The reason why you cant ping the other devices with their static IP config is that the incoming ICMP ping might go to the wrong PVID - this is defining where incoming untagged frames are associated to (which VLAN). I've configured a 3750 with a 3 vlans (1,20,100) to trunk to my 3825.Īll vlans are allowed across the trunk both sides and sub interfaces are configured on the 3825. Cannot telnet to loopback/vlan interface on N2000 (N2048) switch. I have a question/issue regarding pinging between vlans.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |